CheckVideo Gateway Guide d'installation télécharger pdf (Page 11)

7. Click the Security tab to select options to customize data protection settings.

Trigger Receiver Server URL or IP - Enter the IP address or URL of the VideoAlert.net server

(69.20.70.164) or (www.videoalert.net) for the Gateway to send video to the VideoAlert.net server

when triggered.

Trigger Output - When the camera detects moving objects, or one of the (4) trigger inputs is activated,

the trigger output is activated, which may be used to trigger a zone on a security system, etc.. Enter

the duration of the trigger output signal (in seconds)., and the camera will continue to trigger the

device for the length of the time specified. Note: The trigger output signal is sent each time the

Manually Activate Trigger Output button is clicked.

LAG time to Start Guard - Specify the exit delay time (in seconds) allowing the exiting of the protected

area.

Activate Security Function - Click the radio button to select the Security Function type, either

Always or Daily. Select Always to enter security mode when the Trigger In or Motion

Detection functions are activated; select Daily to enter security mode at the specified Video

Gateway Internal Time (in 24-hour military time). See the Main tab, "Video Gateway Internal

Time" for more information.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

CheckVideo Gateway Guide d'installation Page 11